Earthquake CS4116B Manual de usuario descargar pdf (Pagina 18)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 18

Operator's Manual

CS3814B, CS4116B Chainsaws

MAINTENANCE AND STORAGE

Good maintenance is essential for safe, economical, and

trouble-free operation. It will also help reduce air pollution. To

help you properly care for your engine, the following pages in-

clude simple maintenance procedures using basic hand tools.

Other service tasks that are more dicult, or require special

tools, are best handled by professionals and are normally per-

formed by a technician or other qualied mechanic.

NOTE: Maintenance, replacement or repair of the

emissions control devices and systems may

be performed by any non-road engine repair

establishment or individuals. However, items must

be serviced by an authorized dealer to obtain “no

charge” emissions control service.

The maintenance schedule applies to normal operating con-

ditions. If you operate your engine under unusual conditions

(such as sustained high-load or high-temperature operation) or

use it in unusually wet or dusty conditions, consult your servic-

ing dealer for recommendations applicable to your individual

needs and use.

Maintenance Item Every Refueling

Every 8

Hours

Every 20

Hours

Each Year

Check Engine and Check Hardware

X x

Air Filer

(See Air Filter Section)

Check x

Clean X X

Replace X X

Spark Plug

(Gap 0.025” or 0,0635mm)

See Spark Plug Section

Check/Adjust

Replace X

Chain Tension Check/Adjust

Chain

(See Chain Sharpening Section)

Check/Sharpen

Clean X

Replace X

Guide Bar

(See Check Guide Bar Section)

Check X

Clean x

Oiler Port Clean

Drive Sprocket

(See Drive Sprocket Section)

Check/Clean

X X

Grease

X X

Hot Engine Start Procedure:

1. Put ignition switch in the ON position.

2. Pull rope 1-2 times to start.

3. If engine does not re, refer to Warm Engine Start.

Stopping The Engine:

1. Let the saw idle for up to one minute to continue blowing

air through the engine to aid the cool-down process.

Doing so will help prolong the life of the saw.

NOTE: The engine is still running. Always maintain a rm,

controlling grip on the unit while the engine is

running.

2. Put the unit’s ignition switch in the OFF position.

3. Once cooled down and o, remove tension from the

chain.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comentarios a estos manuales

Sin comentarios

Earthquake CS4116B Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Motosierras Earthquake CS4116B